You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
Home > ThinkTel Support > Provisioning > How do I factory reset my ATA and re-provision it?
How do I factory reset my ATA and re-provision it?
print icon

Before you can re-provision a device we have to first remove it from our provisioning server. Please contact the support line at 866-928-4465 options 1-3-1

Resetting the device:

Make sure your ATA has power and internet connection and the lights are solid.

 

Plug a phone into the ATA and perform the following steps.

 

You might have to press 1 after the factory reset some models have to follow with a # i.e.

73738#1 73738#1#

 

"***" will bring you to your phone's configuration menu. You will be asked to enter an option(Below) followed by the # key. After you complete each step, hang up and dial again followed by the next code.

Factory Reset:

  1. ****73738# spells RESET
  2. Enable WAN web admin interface:
    ****7932# - 1 to enable; 0 to disable
  3. Enable LAN web admin interface:
    ****723646# - 1 to enable; 0 to disable
  4. Get IP address:(Be prepared to write the IP down)
    ****110#

Provisioning with ThinkTel:

  1. Log into your ATA's GUI
    a. Locate the ATA's IP
    Dial ****110# from a phone connected to the ATA. Listen and write down the IP that you are told.
    b. Go to your computer, open your web browser, and enter your phone's IP i.e. 
    http://192.168.x.x replacing the x.x part with the ip address obtained from your call above.
  2. Click on "Admin Login" (Top right ) Wait for the screen to reload Click on "advanced" If you get prompted for a password after you reset use admin/admin.
  3. Click on the Provisioning Tab(some versions will be under voice tab) and ensure 'Provision Enable' is set to yes
    a. Set 'Resync Random Delay' to '0'
    b. Set 'Resync Periodic' to '5'
    c. Set 'Profile Rule' to: 
    http://provision.thinktel.ca/init.cfg
  4. Click on 'Submit All Changes'. Your Cisco/Linksys device will reboot up to four times with firmware potentially being upgraded if out of date.

    Please note: It can take 10-20 minutes for your device to populate in our provisioning servers. If the process appears to be taking longer than this, the device may need to be manually rebooted by unplugging/re-plugging the power supply.
  5. Provision device:
    1. Contact our Orders team after the Reset/Re-provisioning to complete the device configuration (ie. re-add a number to the ATA configuration).
    2. Provision VIA uControl. Instructions: https://support.thinktel.ca/kb/article/241-Provisioning_Device

Quote your device MAC address when placing orders for VoIP service on your Cisco/Linksys hardware.  Please send an email to ordrs@thinktel.ca.

Feedback
0 out of 0 found this helpful

scroll to top icon